This is an E/A0-sized (48") black and white inkjet plotter. It uses Canon bubblejet ink cartridges, which are easy to obtain and inexpensive. It supports HPGL/2, HP-RTL, CalComp 906/907, CALS 1/2, IOCA, TIFF, TRIFF, ACCESS, GTX and Formtek protocols, and emulates a wide variety of HP plotters (all of which are natively supported in AutoCAD). It can print at up to 720 DPI and is in excellent mechanical and physical shape.

This plotter has been used less than 100 times. It was purchased (slightly used - off of eBay) for a project that never came to fruition. It is perfect for a mechanical engineer or architect and can handle large workloads due to its quick plots.

This unit can handle both sheet-fed paper and roll-fed paper. Included in the sale is 150' of 36" and 24" paper as well as an assortment of cut sheets.

Image(s):

Specifications and Features:

• 720 DPI
• E/A0 size (plotted in approximately 6 minutes)
• Serial (RS-232) and parallel interfaces
• 100" maximum plot length
• Can take both sheet-fed and roll-fed paper
• Handles plain paper, translucent, bond, vellum, polyester film and fine coated paper
• HPGL/2, HP-RTL, CalComp 906/907, CALS 1/2, IOCA, TIFF, TRIFF, ACCESS, GTX, Formtek protocols handled natively
• Postscript handled optionally
• 52 1/4" x 12 7/8" x 13" plotter size
• 52 1/4" x 12 7/8" x 43 7/8" size with stand (included)
• 75 watt maximum draw
• Less than 54dB noise
• Network interface optional

Further Information:

• None Available